![]() ![]() It was all working just fine untill a couple of days ago.Īnyone has any idea, what to try next? I need dnc, I am making mold tools.ĭNC - A two-second dwell is required between the DNC command and the first percent symbol (%). Went to my friend and took his pc with com port, tried it - the same thing happens. ![]() I haven't had a blind plug for db25 on the machine, so I connected pins 2 and 3 with a bridge, hope its ok (and enough, manual says that's done in the blind plug)Ĭonnected my rs 232 cable on the machine, and connected by bridge pins 2 and 3 on the db9 side, ran communication test again and its ok. Went to diagnostic mode and ran communication test - it is ok. Looked at my rs232 9 to 25 cable, everything in place like the times it worked.Ĭhecked cimco dnc settings - all seems ok, baud rate, parity, Xon Xoff. Looks to me like Xon Xoff signal is missing. But now all code seems to be sent to the machine, although the buffer is full. Normaly when I dnc my code, my pc sends first portion of code, progress bar on cimco window stops, then I hit green button and the machine is working ok. I get "transfer completed sucsessfully" message on my cimco window. Seems to me like the buffer is full, and the control does not receive any more code (I guess that the control is not "asking" external pc for more code, or is asking, but the computer somehow is not delivering). I can not run the whole program, the machine "runs out" of g-code after few dozen lines. Trying to drip feed a program - and this is what I get: ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |